I have a MakerGear M2 at work, and was curious to see how much overlap there is in this community.
![Image](https://uploads.tapatalk-cdn.com/20190110/75624a5e22f7e5244350412f99398a59.jpg)
You can find my Thingiverse page at https://www.thingiverse.com/LabsOfCogn ... ence/about
Sent from my iPhone using Tapatalk
Does anyone need one? Not really. It just takes away tooling costs and makes some fabrication repeatable and trivial. I have been able to make things that weren’t commercially viable that a small community actually needed. The parts weren’t anything that couldn’t have otherwise been made,but the trial and error costs became negligible and part cost was minimal for the utility.ManOnTime wrote:I want one, I have no need for one, but I want one.
That would be a pretty good use case. I would have to look at the shroud design, but it should be doable. You could have a number of shrouds and swap in the right color as desired.Robotaz wrote:I want to print tuna shrouds.